INSTRUMENT TECHNICIANS
SAUDI TSS, Saudi Arabia
OMANFIL INTERNATIONAL MANPOWER DEVELOPMENT CORPORATION
DMW License No: POEA-093-LB-072910-PA2ND FLOOR RODEO BUILDING 802 KM 18 WEST SERVICE ROAD SOUTH SUPERHIGHWAY PARANAQUE, PARANAQUE CITY, Metro Manila, Philippines
8-821-1650 TO 55
Principal / Employer
KENTZ ENGINEERS & CONTRUCTORS
Qualifications
Male25 Years Old and AboveMinimum of 3 Years ExperienceAt Least Vocational Diploma / Short Course CertificateQualifications:
- Candidates must have at least Vocational Diploma / Short Course Certificate.
- The job requires Male applicants only
- Minimum of 3 years working experience is required for this position.
- Applicants must be 25 to ████████████
-
1. Foundation Field Bus experience is a must.
2. Responsible for the evaluation and correctness of all technical data from the client.
3. Ensure that all test equipment is calibrated and maintained in good order.
4. Ensure that monthly inspection records are carried out on all test equipment.
5. Ensure that any variation to the scope of work is advised immediately to the supervisor.
6. Maintain and update loop packs at all times.
7. Maintain proper housekeeping in the calibration shop at all times.
8. Calibrate all instruments in accordance with their data sheets.
9. Loop check according to the ILD.
10. Liase with the site planner and ensure timely progression of the works. Advise any potential problems or delays to the Project Manager.
11. Ensure that proper quarantine procedure is carried out where applicable for damaged equipment/material.
12. Should be able to troubleshoot and repair plant instrument problems “Pneumatics and Electronics”
13. Should be able to work on PLC, DCS and Smart Instruments.
14. Read and understand loop drawings and P & ID’s.
15. Able to tune field controllers, adjustment P & ID setting and tune the loop.
16. Experience in troubleshooting combustion control loops, steam boilers/furnaces.
17. Carryout testing safety critical devices/systems according to the safety critical procedures.
18. Ensure that all loop checking is carried out timely and to the proper procedures.
19. Ensure that the client signs off all loops.
20. Maintain all test records for both calibrations and loop checks to QC.
21. Ensure all corrections are redlined on specification sheets and drawings.
22. Any other adhoc duties as assigned from time to time.